1) How to make cross over & straight cable
2) How to connect 2 pcs via cross cable
3) How to connect 2 pcs wireless
4) How to connect 2 pcs via switch
5) Sharing internet from pc/lab top to mobile
Section 1: 1) Making crossover cable & Straight through
First side in any cable arrange as standard B as follows
Put the wires in the following order, from left to right:
white orange
orange
white green
blue
white blue
green
white brown
brown
in Straight through: both sides are the same (in the same order of wires)
In cross over
Section 2: Connecting two PCs using a crossover Ethernet cable
1) connect 2 pcs via cross over cable
2) put ip in 2 pcs
control panel—network and internet—network and sharing center--click on Change adapter
settings-- Right-click on your local adapter and select Properties. -- In the Local Area
Connection Properties window highlight Internet Protocol Version 4 (TCP/IPv4) then click
the Properties button-- Now select the radio button Use the following IP address and enter in
the correct IP (192.168.1.1) and second pc (192.168.1.2)
3) turn on network discovery & file sharing & turn off password. (How???)
use ping to test that 2 pcs connected
on pc1
open cmd and write ping (ip of second pc)
if reply then it works well.
4) Under Network you will find 2 pcs and then you can share folders. (How to share ??).
Section 3: -
Connecting 2 lab tops wireless:
1) Open hotspot from your mobile
2) Connect your 2 lab tops to our mobile
3) Repeat same steps of connecting 2 pcs through cross over cable.
To share internet from pc to mobile:
1) Connect your mob to pc via usb then check on usb debugging.
2) Install usb reverse tethering tool on your mobile and you can share
internet.
To share internet from Lab top to mobile:
There are very tools to do that but one of them is virtual router
1) Install it on your Lab top
2) Follow steps as below
3) Turn Wi-Fi on your mobile & enter network name & password
4) Connected and you have shared internet.
How to connect 2 pcs via switch
Same steps will repeat when connected 2 pcs via cross over cable