DPMS receiver rug

Published on December 2018 | Categories: Documents | Downloads: 12 | Comments: 0 | Views: 278
of 11
Download PDF   Embed   Report

Comments

Content

Ammended Receiver Rug Installation Instructions 1. Correct Orientation of the fire control group. (Pic 1) 2. Using drift punch, remove hammer pin and hammer. (Pic 2) 3. Note correct hammer spring position (Pic 3) 4. Remove pistol grip (Pic 4) 5. Please note: the pistol grip contains the detent spring for the safety selector. (Pic 5) 6. Also note: the safety selector detent located in the lower receiver..please remove. (Pic 6) 7. Remove safety selector. (Pic 7) 7) 8. Using drift punch: remove trigger pin (Pic 8) 9. Please note the orientation of the trigger spring. (Pic 9) 10. Please note the orientation of the trigger, disconnector, and trigger spring. (Pic 10) 11. Correct orientation of the receiver rug under the trigger group. (Pic 11) 12. Correct orientation of the receiver rug in the lower receiver. (Pic 12) 13. Be certain that each leg of the receiver rug is free along the sides of the trigger. (Pic 13) If you “pinch” these legs under the trigger tail during installation, it will not allow the trigger to reset properly, creating a single shot rifle. 14. Re-install safety selector, then safety selector detent. (Pic 14) 15. Re-install the safety selector spring in the pistol grip. (Pic 15) 16. Be certain the safety selector spring fits in the appropriate hole in the lower receiver. (Pic 16) 17. Correct installation of the receiver rug in the lower receiver (Pic 17) 18. Correct hammer spring orient orientation. ation. (Pic 18) 19 Re-inst Re-install all hammer in lower receiver. receiver. (Pic 19) 20. Job complete (Pic 20) Function Check: With the magazine removed; visually and physically inspect the chamber to verify and confirm the rifle is UNLOADED. Place the safety selector in the Safe position. position. Point the rifle rifle in a safe direction direction and pull the trigger trigger.. Nothin Nothing g should happen. happen. Place the safety safety selector selector in the fire position. position. Point the rifle rifle in a safe direction. direction. Pull the trigger trigger and hold it to the the rear. rear. Do not release release the trigger trigger.. The hammer hammer should fall. fall. Witho Without ut releasing releasing the trigtrigger,, re-cock the hammer using the charging ger charging handle. Releas Release e the trigger. trigger. An audible click click should be heard as the disconnector releases the hammer to the sear portion of the trigger. Return the safety selector to the safe position. If the trigger does not function as described above, please contact DPMS Customer Service for additional addit ional assistance. assistance. The trigger mechanism mechanism should operate exactly exactly as it does without the receiver rug instal installed. led.

PIC 1 Back To Top

PIC 2 Back To Top

PIC 3 Back To Top

PIC 4 Back To Top

PIC 5 Back To Top

PIC 6 Back To Top

PIC 7 Back To Top

PIC 8 Back To Top

PIC 9 Back To Top

PIC 10 Back To Top

PIC 11 Back To Top

PIC 12 Back To Top

PIC 13 Back To Top

PIC 14 Back To Top

PIC 15 Back To Top

PIC 16 Back To Top

PIC 17 Back To Top

PIC 18 Back To Top

PIC 19 Back To Top

PIC 20 Back To Top

Sponsor Documents

Or use your account on DocShare.tips

Hide

Forgot your password?

Or register your new account on DocShare.tips

Hide

Lost your password? Please enter your email address. You will receive a link to create a new password.

Back to log-in

Close