ECET 330 Week 4 iLab Introduction to Tower Module
Click Below Link To Purchase
www.foxtutor.com/product/ecet-330-week-4-ilab-introduction-to-tower-module
Objectives:
1.To set up the Tower System
2.Become familiar with programming and using the Tower Module
3. Become familiar with I/O port programming
Results:
I learned how to Set up the Tower Module and connect it to the PC.
Conclusions:
The Module tower has four green LEDs connected to Port T. Each LED is configured for active low operation. As this is done, it turns the LED on, when a 0 is sent to it. I also became familiar with programming and using the Tower Moduleto program I/O ports.
Comments
Content
ECET 330 Week 4 iLab Introduction to Tower Module
Click Below Link To Purchase
www.foxtutor.com/product/ecet-330-week-4-ilab-introduction-to-tower-module
Objectives:
1.To set up the Tower System
2.Become familiar with programming and using the Tower Module
3. Become familiar with I/O port programming
Results:
I learned how to Set up the Tower Module and connect it to the PC.
Conclusions:
The Module tower has four green LEDs connected to Port T. Each LED is configured for active low operation. As this is done, it turns the LED on, when a 0 is sent to it. I also became familiar with programming and using the Tower Moduleto program I/O ports.