ECT 122 Week 5 iLab 2
Click Below Link To Purchase
www.foxtutor.com/product/ect-122-week-5-ilab-2
1.Calculate the quantities listed.
2.Download the Multisim file “Ser_Par2” from Doc Sharing, Week 5. Run the simulation and verify the simulated results are the same as the calculated values. Were the values the same? Yes/No. If no, why?
3.Construct the circuit above on the breadboard. Connect the circuit’s input to the power supply and set it to +10 V. Use the handheld DMM to adjust the supply to +10 V. Using the handheld DMM, measure the values below. Remember, to measure current, the DMM must be in series with the resistor. Have the professor verify the circuit before applying power.
Comments
Content
ECT 122 Week 5 iLab 2
Click Below Link To Purchase
www.foxtutor.com/product/ect-122-week-5-ilab-2
1.Calculate the quantities listed.
2.Download the Multisim file “Ser_Par2” from Doc Sharing, Week 5. Run the simulation and verify the simulated results are the same as the calculated values. Were the values the same? Yes/No. If no, why?
3.Construct the circuit above on the breadboard. Connect the circuit’s input to the power supply and set it to +10 V. Use the handheld DMM to adjust the supply to +10 V. Using the handheld DMM, measure the values below. Remember, to measure current, the DMM must be in series with the resistor. Have the professor verify the circuit before applying power.