Juniper Login

Preparing for juniper router configuration Requirement: 1. Console cable and USB to Serial port cable 2. LAN cable Physical Setup 1. Connect the Lan cable to equipment. Connect to console port 2. Connect the LAN cable to Serial port 3. Connect the Console cable to USB to Serial port cable 4. Connect USB cable to Laptop Steps: Running the Hyper Terminal 1. Setup configuration

Go to hyper terminal page

Default login-root Prompt%-cli Prompt>-Use for PING,TRACE,show configuration Prompt#To configure device 2. Troubleshooting Command show configuration| display set show vrrp brief show route <ip> show interface terse ping <destination ip> source <source interface ip> show bgp neighbor