Aeronautical Engineering Design I
Landing Gear Sizing and Placement
Prof. Dr. Serkan Özgen
Dept. Aerospace Engineering
November 2015
Landing gear configurations
2
Tricycle landing gear
3
Tricycle landing gear
• Advantages of tricycle landing gear:
⁻ Cabin floor is horizontal when the airplane is on the
ground.
⁻ Forward visibility is improved for the pilot when the
airplane is on the gound.
⁻ The CG is ahead of the main wheels and this enhances
stability during the ground roll.
4
Tricycle landing gear
5
Tricycle landing gear
• The length of the landing gear must be set so that the tail
doesn’t hit the ground during landing.
• This is measured from the wheel in the static position
assuming an angle of attack for landing that gives 90% of
maximum lift, usually 10o-15o.
• The tipback angle is the maximum aircraft nose-up attitude
when the tail is touching the ground and the landing gear
strut is fully extended.
• To prevent the aircraft from tipping back on its tail, the angle
of the vertical from the main wheel position to the cg should
be greater than the tipback angle or 15o, whichever is greater.
6
Tricycle landing gear
• Tipback angle should not be greater than 25o, otherwise
porpoising will occur and a high elevator deflection will be
required for rotation during takeoff.
• This means that more than 20% of aircraft weight is carried by
the nose wheel.
• The optimum range for the percentage of aircraft weight that
is carried by the nose wheel is 8-15% for the most aft and
most forward CG positions.
• If it is less than 5% there won’t be enough traction to steer.
7
Tricycle landing gear
• Overturn angle is a measure of the aircraft’s tendency to
overturn when turned around a sharp corner.
• This is the angle between the CG and the main wheel seen
from the rear. This angle should not be greater than 63o.
• The landing gear should be long enough for a propeller
clearance of at least 9″.
8
Taildragger landing gear
9
Taildragger landing gear
10
Taildragger landing gear
• Advantages of taildragger landing gear:
⁻ Propeller clearance is greater.
⁻ Takeoff distance is shorter because the wing is at a high
angle of attack when the airplane is on the ground.
• For this configuration, the main wheels are ahead of
the CG, which is an unstable configuration during
ground roll.
• Also, forward visibility is poor for the pilot when on
ground.
• The bicycle landing gear is useful for high-wing
airplanes with long span.
11
Taildragger landing gear
• The taildown angle ≈ 10o-15o.
• The CG (most aft and forward) should fall between
16o-25o back from the vertical measured from the
main wheel location.
• The wheels must be separated beyond 25o of the CG
measured from the rear to prevent overturn.
12
Taildragger landing gear
13
Taildragger landing gear
14
Bicycle landing gear
15
Tyre sizing
• Tyre size depends on the load carried by each tyre.