Interface
Content
channel zone
evaporation-interface
porous zone
I defined interfaces in Gambit at the overlap of the two zones.
Now I am create the evaporation interface in fluent.
The question is the which kind of interface options should I choose.
I was intended to choose the coupled wall, however it only coupled the wall heat
transfer, no fluid flow, which can be seen below.
I could not go on without a specific definition about the interface.
Please help. Thank you.
This is from fluent 14 user's guide
evaporation-interface
porous zone
I defined interfaces in Gambit at the overlap of the two zones.
Now I am create the evaporation interface in fluent.
The question is the which kind of interface options should I choose.
I was intended to choose the coupled wall, however it only coupled the wall heat
transfer, no fluid flow, which can be seen below.
I could not go on without a specific definition about the interface.
Please help. Thank you.
This is from fluent 14 user's guide
