Single Cylinder Stirling Engine

Published on November 2016 | Categories: Documents | Downloads: 40 | Comments: 0 | Views: 172
of 2
Download PDF   Embed   Report

Stirling Cycle



Single Cylinder Stirling Engine
This type of Stirling engine, known as the beta configuration, features just one cylinder with a
hot end and a cool end. The working gas is transferred from one end of the cylinder to the other
by a device called a displacer (illustrated in blue). The displacer resembles a large piston, except
that it has a smaller diameter than the cylinder, thus its motion does not change the volume of
gas in the cylinder—it merely transfers the gas around within the cylinder.

The same four phases of the Stirling cycle are at work in this engine:


Most of the gas in the system has just been driven to the hot end of the cylinder. The gas heats
and expands, driving the piston outward.


The gas has expanded. Most of the gas is still located in the hot end of the cylinder. Flywheel
momentum carries the crankshaft the next quarter turn. The bulk of the gas is transferred around
the displacer to the cool end of the cylinder.


The majority of the expanded gas has shifted to the cool end. The gas cools and contracts,
drawing the piston inward.


The contracted gas is still located near the cool end of the cylinder. Flywheel momentum carries
the crank another quarter turn, moving the displacer and transferring the bulk of the gas back to
the hot end of the cylinder.
Disponível em:

Sponsor Documents

Or use your account on


Forgot your password?

Or register your new account on


Lost your password? Please enter your email address. You will receive a link to create a new password.

Back to log-in