T
VPN SETUP INSTRUCTIONS
1. Press the Start button and click Control Panel. A new window will open up and then
click “View Network Status and Tasks” under “Network and Internet” as below.
2. Click “Setup a new Network Connection” as marked below
Page 1 of 6
T
3. Click “Connect to Workplace” as marked below
4. Now Click “Use my Internet Connection (VPN)” as marked below
Page 2 of 6
T
5. In next window, please add the following things as marked below:
a. Internet Address= 96.56.206.85
b. Description= “MY VPN” or whatever you want
c. Check the box “Don’t connect now, just set it up so I can connect later”
d. Then press “Next” button
Enter the username= [given to you in email]
Password= [given to you in email]
Check the box remember password. Then click “Create” button
Page 3 of 6
T
6. After this click Close. Then click Change Adapter Settings as shown below
7. Right click “MY VPN” and click Properties as shown below
Page 4 of 6
T
8. Click Networking tab, then select Internet Protocol Version 4 (TCP/IP) and press
Properties button
9. Click Advanced
Page 5 of 6
T
10. Uncheck the “Use default Gateway on Remote Network”. Press OK button.
Click OK and click OK again.
11. Right Click on “MY VPN” and click Connect
And you get a message that “MY VPN” is now connected.